80,000 lb. IRD Balancing Machine, 72" swing, ext.bed, 75 HP D.C.dr, Micro-Processor control, instrumentation, exc. condition

(1) Used 80,000 lb. IRD Balancing Machine Specifications: Weight Capacity.........................................80,000 lbs. Max. Weight Per Support.................................45,000 lbs. Min. Weight.............................................500 lbs. Min. achievable residual unbalance per plane............0.000005 in. (0.000127 mm) Swing...................................................72" Unbalance Reduction Ratio...............................95% Max. Radius Over Whip Indicator.........................9" + distance from flat mounting surface to centerline of shaft Max. Diameter Driven by Belt............................60" Min. Diameter Driven by Belt............................4" Max. Distance Between Support Pedestal Centerlines......43' 6" Min. Distance Between Support Pedestal Centerlines......21" Height of Flat Mounting Surface from Floor..............40 1/4" Belt Drive..............................................Continuous Flat Belt Belt Width..............................................3" Drive Motor.............................................75 HP, 500 VDC Variable Speed Motor Speed.............................................125-1750 RPM Rated Torque............................................150 lb.-ft. Drive Pulley Diameter...................................12" Balancing Speed.........................................250-4000 RPM Max. Belt Speed.........................................5,500 ft./min. Required Air Supply.....................................70-100 psi @ 0.5 cfm Max. Setup Length.......................................45' Min. Setup Length.......................................22' 2 Section Lengths.......................................11' Width...................................................4' Height..................................................10 1/4" Electrical Characteristics..............................460 VAC / 3 Phase / 50/60 Cycle / 75 Amps Equipped With: Full Roller Supports Extended Bed Adjustable Centers Micro-Processor Controls Instrumentation Regenerative Brake Installation Requirements: Foundation: Normal 6" thick reinforced concrete floor. No special heavy substructure required. Base to be lagged to floor with standard expandable concrete anchors. Control console does not require lagging. Replacement Cost Over $180,000 Overall Dimensions......................................52' L x 147" W x 48" H Weight.................................................. FOB.....................................................Casa Grande, AZ